Pond liner lifting, bubbling, or floating is usually caused by groundwater accumulating beneath the liner. The resulting water pressure, known as hydrostatic pressure, can push the liner upward. Trapped air, naturally occurring gases, or water escaping from a pond leak may also cause the liner to bulge.
What causes a pond liner to lift or bubble?
Common causes include:
- High groundwater levels: Water accumulates beneath the liner and pushes it upward.
- Heavy rainfall or melting snow: Saturated ground increases groundwater pressure.
- Low pond water levels: Draining the pond reduces the water pressure that normally holds the liner in place.
- Pond leaks: Escaping pond water may collect beneath the liner.
- Trapped air or gas: Air or gases from decomposing organic matter can accumulate beneath the liner, creating bubbles or raised areas.
How can I determine the cause?
- Pond is losing water: Inspect the pond, plumbing, and waterfall for possible leaks.
- Pond is not losing water: Groundwater is a likely cause, particularly after heavy rainfall or snowmelt.
- Liner lifts during a cleanout: Groundwater pressure may be pushing the liner upward after the pond has been drained.
- Large bubbles or raised areas appear: Water, trapped gas, or a combination of both may be responsible.
What should I do if the liner lifts during a cleanout?
- Assess the size of the bulge and determine whether groundwater is present.
- If the liner remains properly positioned and the bulge is manageable, carefully work around the raised area while completing the cleanout.
- Do not force the liner down or attempt to puncture it.
- Once cleaning is complete, gradually refill the pond.
- The weight of the water may help push the liner back into position as groundwater pressure decreases.
- Monitor the liner over the following several days as conditions stabilize.
Important: If the liner becomes significantly displaced or continues lifting, consult a qualified pond contractor before proceeding.
Will the liner settle back into place?
In many cases, yes. If groundwater caused the bulge, the liner may gradually settle as groundwater levels recede and the pond is refilled.
If a leak caused the water accumulation, repair the leak first. Water beneath the liner may then gradually seep into the surrounding soil.
What if groundwater continues to accumulate?
For persistent or excessive groundwater, additional drainage may be necessary.
- Sump pit: A sump pit installed adjacent to the pond and deeper than the pond bottom can collect groundwater. A submersible pump can then remove the collected water.
- Pressure-relief valve: In certain ponds approximately 5 ft (1.5 m) deep or deeper, a pressure-relief valve may be an option for relieving groundwater pressure beneath the liner. Suitability depends on the pond's construction.
- Manual water removal: A wet/dry vacuum may remove small amounts of accessible water but is not practical for continuous or significant groundwater accumulation.
An adjacent sump pit is generally the more practical option for shallow ponds experiencing persistent groundwater problems. Consult a qualified pond contractor to determine the appropriate drainage solution.
Important: Never puncture, cut, or modify the pond liner to release trapped water without an appropriate professional repair or drainage plan. Doing so can create a permanent leak.