The correct waterfall width depends on your pump's flow rate, measured in gallons per hour (GPH), and the type of water flow you want to create.
As a general guideline, allow 1,500 GPH (5,678 LPH) for every 1 ft (30 cm) of waterfall width to create a continuous sheet of water. A stronger, more turbulent waterfall requires additional flow.
Recommended flow rates
- Sheet waterfall: 1,500 GPH (5,678 LPH) per 1 ft (30 cm) of waterfall width.
- Heavy white-water waterfall: 3,000 GPH (11,356 LPH) per 1 ft (30 cm) of waterfall width.
How to calculate waterfall width
Divide your pump's actual flow rate by the recommended flow rate per foot.
Example: A pump delivering 3,000 GPH (11,356 LPH)
- Sheet waterfall: 3,000 ÷ 1,500 = 2 ft (61 cm) wide.
- Heavy white-water waterfall: 3,000 ÷ 3,000 = 1 ft (30 cm) wide.
These calculations provide approximate waterfall widths. Actual results depend on waterfall design and water distribution.
Account for head height and plumbing
A pump's advertised maximum flow rate is not necessarily the amount of water reaching your waterfall.
The actual flow rate decreases as water is pushed uphill and encounters resistance from plumbing.
Consider the following:
- Waterfall height: The vertical distance the pump must lift water.
- Pipe length and diameter: Longer or undersized plumbing can reduce flow.
- Fittings and elbows: Additional fittings increase resistance.
- Pump performance: Use the manufacturer's pump performance chart to determine the expected GPH at your system's total dynamic head.
Important: Calculate waterfall width using the pump's expected flow rate at the waterfall, not its maximum advertised GPH.
For waterfalls with multiple drops or varying widths, use the widest section when determining the required flow.
If using a BioFalls filter or Waterfall Spillway, make sure the selected product can accommodate the expected pump flow rate.