Regular cleaning of your EcoWave Pond Pump helps prevent debris and mineral buildup that can reduce water flow and affect pump performance. Follow these steps to clean the filter screens, impeller, and internal pump components.
These instructions apply to the EcoWave 2000, 3000, 4000, and 5000 pond pumps.
How to clean an EcoWave pond pump
- Disconnect power. Unplug the pump from its GFCI-protected outlet before removing it from its installation. Never lift the pump by its power cord.
- Remove the outer filter screen. Gently push down on the top of the screen to release it.
- Remove the inner filter screen. Unscrew the inner screen from the pump intake.
- Clean both filter screens. Remove accumulated debris and buildup. For stubborn deposits, use Aquascape Pump Cleaner Maintenance Solution — Item #91143.
- Remove the water chamber cover. Unscrew the four screws securing the cover.
- Remove the impeller. Gently pull the impeller out of the pump.
- Clean the impeller and pump interior. Use Aquascape Pump Cleaner Maintenance Solution (Item #91143) with a sponge or soft-bristled brush.
- Reinstall the impeller. Align the three tabs as illustrated in the EcoWave Pond Pump instruction manual.
- Reassemble the pump. Secure the water chamber cover with its four screws, then reinstall the inner and outer filter screens.
Important: Never operate the EcoWave Pond Pump without both filter screens securely installed. Operating the pump without the screens can allow debris to enter and damage the pump, voiding the warranty.
Before restarting, ensure the pump is fully assembled and has an adequate water supply. Never allow the pump to run dry.
For additional product information, visit the EcoWave Pond Pumps product page.