If your Aquascape Smart Control device will not pair, connect to Wi-Fi, appears offline, or stops responding, check the power supply, Wi-Fi connection, and pairing status.
These troubleshooting steps apply to the Smart Control Hub, Smart Control Plug, Smart Pump Receiver, and Smart Pond Thermometer.
Device will not connect or pair
- Check power: Confirm the device is receiving power and the GFCI outlet has not tripped.
- Check Wi-Fi: Ensure the device has a strong 2.4 GHz Wi-Fi connection.
- Verify network information: Confirm the Wi-Fi network name and password are entered correctly.
- Restart the router: Restart your wireless router and allow it to reconnect.
- Check pairing mode: A blinking blue indicator light means the device is ready to pair.
- Reset the device: If pairing still fails, follow the device-specific reset instructions below.
Device appears offline
If your Smart Control device previously worked but now appears offline:
- Confirm the device has power and adequate 2.4 GHz Wi-Fi coverage.
- For a Smart Control Plug, disconnect and reconnect the power.
- Restart the wireless router.
- If the connection is not restored, follow the applicable reset procedure below.
How to reset your Smart Control device
- Smart Control Hub: Hold the pairing button for 10 seconds until the blue light flashes rapidly.
- Smart Control Plug: Hold the pairing button for 10 seconds until the indicator light flashes rapidly.
- Smart Pump Receiver: Disconnect and reconnect power. Turn the receiver off so the LCD screen is blank. Hold the + and – buttons simultaneously for 4 seconds until the display shows 8888.
- Smart Pond Thermometer: Hold the F/C button for 10 seconds until the blue indicator light flashes rapidly.
After resetting, open the Aquascape Smart Control App, select Add New Device, and follow the pairing instructions.
Smart Pump Receiver error messages
- E1 – High voltage: Incoming voltage exceeds 142 V. Stop using the receiver and have a qualified electrician inspect the electrical supply.
- E2 – Overheating: Move the receiver to a cooler, shaded, well-ventilated location away from direct sunlight.
- Circuit breaker tripped: The internal breaker may have activated because of an electrical fault or pump short circuit. The receiver instructions specify replacing the affected pump before resetting the breaker. Contact Aquascape Customer Care if the cause is uncertain.
- Pump not responding to app: Confirm the receiver's operating switch is in Position 1 for app or remote control. Position 2 bypasses Smart Control and operates the pump at full flow.
Smart Control Hub lights are not responding
- Confirm the 12 V transformer is receiving power.
- Check the antenna and 5-pin lighting connections.
- Verify the connected color-changing lights do not exceed the hub's 150 W capacity.
- Ensure the hub is protected from direct water exposure.
Still having trouble?
If the device continues to malfunction after troubleshooting, submit a request through the Aquascape Customer Care contact form.
Include your device type, the problem, and any displayed error messages.