The pump, skimmer, and BioFalls in your Aquascape Pond Kit are connected using the supplied plumbing and fittings. The pump sits inside the skimmer and pushes water through the plumbing to the BioFalls, where the water is filtered before returning to the pond through the waterfall.
Step 1: Position the skimmer and BioFalls
- Position the skimmer at the opposite end of the pond from the waterfall to promote proper water circulation.
- Position the BioFalls at the beginning of the waterfall or stream.
- Level the BioFalls from side to side, with a slight forward tilt of approximately 1/4 in. (6 mm) toward the pond.
Step 2: Connect the pump inside the skimmer
- Attach the supplied dual union check valve assembly to the pump's discharge opening.
- Place the pump and check valve assembly inside the skimmer.
- Route the plumbing through the designated opening in the skimmer.
- Connect the plumbing to the check valve assembly and securely tighten the connection.
Step 3: Run the plumbing to the BioFalls
- Route the supplied plumbing along the outside perimeter of the pond excavation toward the BioFalls.
- Place the plumbing in a shallow trench to protect it from damage and conceal it beneath the landscaping.
- Avoid sharp bends or kinks that could restrict water flow.
Step 4: Connect the plumbing to the BioFalls
- Install the appropriate fitting into the BioFalls bulkhead inlet.
- Apply thread sealant or PTFE thread-seal tape where required for the fitting.
- Cut the plumbing to the appropriate length.
- Secure the plumbing using the connection method appropriate for the supplied pipe:
- Flexible PVC: Use the appropriate PVC fittings and compatible PVC cement.
- Corrugated kink-free tubing: Secure the tubing to the appropriate hose adapter using a stainless steel hose clamp.
Step 5: Fill the pond and test the connections
- Fill the pond to the appropriate operating water level at the skimmer opening.
- Make sure the pump is fully submerged before connecting it to power.
- Turn on the pump and confirm that water flows into the BioFalls and returns to the pond through the waterfall.
- Inspect all plumbing connections for leaks.
- Correct any leaks before backfilling and covering the plumbing.
Important: Never operate the pond pump without sufficient water. Running the pump dry can cause permanent damage.
For additional installation guidance, watch the Aquascape Pond Kit installation video.