The Aquascape DIY Backyard Waterfall Kit (Item #83001) uses an EcoWave 2000 Pond Pump inside the Pondless Waterfall Vault. The pump connects to the Waterfall Spillway using kink-free pipe and hose clamps, allowing water to circulate from the underground reservoir to the top of the waterfall.
Step 1: Connect the pump inside the vault
- Attach the pump fitting. Install the rotational ball fitting included with the EcoWave 2000 pump onto the pump discharge.
- Check the washer. Make sure the flat rubber washer is properly positioned inside the fitting to create a watertight connection.
- Hand-tighten the fitting. Do not use tools to tighten fittings onto the pump discharge.
- Route the pipe. Feed the kink-free pipe through the slot on the side of the Pondless Waterfall Vault.
- Position the pump. Lower the pump into the vault and rotate the ball fitting to align it with the pipe.
- Secure the connection. Push the pipe onto the fitting and secure it with the included hose clamp.
Step 2: Route the plumbing to the Waterfall Spillway
- Run the kink-free pipe around the outside perimeter of the reservoir toward the waterfall.
- Dig a shallow trench or conceal the pipe with soil, rocks, or mulch.
- Trim the pipe to the required length, ensuring there is enough pipe to reach both connections without unnecessary tension.
- Avoid sharp bends or kinks that could restrict water flow.
Step 3: Connect the pipe to the Waterfall Spillway
- Position the spillway. Place the Waterfall Spillway on a stable, level base at the top of the waterfall.
- Position the liner. Fold the liner over the spillway, leaving some slack for adjustments.
- Mark the opening. Make a small reference hole in the liner through the center of the spillway bulkhead.
- Cut the liner. Use the retaining nut to mark the opening and cut approximately 1/8 in. (3 mm) inside the marked circle.
- Install the gaskets. Position the liner over the bulkhead so it is sandwiched between the two rubber gaskets.
- Secure the retaining nut. Hand-tighten the reverse-threaded nut in the direction indicated by its arrow. Carefully tighten an additional 1/4–1/2 turn with channel-lock pliers. Do not overtighten.
- Attach the barbed fitting. Apply the included silicone sealant to the threads of the male pipe-thread (MPT) barbed fitting and install it into the back of the spillway.
- Connect the pipe. Push the kink-free pipe over the barbed fitting and secure it with the included hose clamp.
Step 4: Test the connections
- Fill the underground reservoir with water.
- Confirm the pump is fully submerged.
- Allow any waterfall foam sealant to cure for at least one hour before introducing water.
- Connect the pump to a properly grounded, GFCI-protected outdoor outlet.
- Check the plumbing connections for leaks and confirm water flows evenly through the spillway.
- Check the reservoir water level through the vault's inspection port and add water as necessary.
Important: Never operate the pump without sufficient water. Keep the pump disconnected from electrical power while making plumbing adjustments.
For additional installation guidance, refer to the DIY Backyard Waterfall Kit product page, which includes the installation instructions.