The Pro Air 20 Pond Aeration Kit (Item #61009) and Pro Air 60 Pond Aeration Kit (Item #61008) provide aeration for ponds and water features. Proper installation, routine maintenance, and occasional cleaning help maintain consistent airflow and reliable operation throughout the year.
Both systems can operate outdoors, including during freezing weather.
Installation and weather protection
Pro Air 20 and Pro Air 60 compressors are outdoor-rated and do not require additional weather protection during normal operation.
For proper installation:
- Position the compressor on a stable surface, preferably above the pond's water level.
- Connect the compressor to a ground fault circuit interrupter (GFCI)-protected electrical outlet.
- Connect the supplied airline tubing to the compressor. The Pro Air 60 requires installation of its included two-way manifold.
- Confirm that the pre-installed check valves allow airflow toward the diffusers.
- Secure the tubing connections using the supplied stainless steel hose clamps.
- Position the aeration diffusers in the pond.
- Connect power and verify that bubbles are coming from the diffusers.
Important:
- Never submerge the compressor in water.
- Check valves must be installed correctly to prevent water from flowing backward into the compressor.
- Do not operate the compressor with severely restricted airflow.
Other Aquascape aerators: The 2-Outlet Pond Aeration Kit (Item #75000) and 4-Outlet Pond Aeration Kit (Item #75001) are not rated for outdoor exposure. Their air pumps must be installed in a dry, protected indoor location.
Should I use weighted aeration tubing?
Weighted aeration tubing is recommended when the airline runs through the pond, but it is not required for either the Pro Air 20 or Pro Air 60.
Both kits include standard braided airline tubing that works without upgrading.
Weighted tubing provides several advantages:
- Sinks naturally and stays at the bottom of the pond.
- Prevents the airline from floating or becoming visible.
- Eliminates the need for separate tubing weights.
- Makes tubing easier to conceal among rocks and gravel.
Aquascape Weighted Aeration Tubing has a 3/8 in. (9.5 mm) inside diameter and is compatible with both systems.
Available tubing lengths:
- 25 ft (7.62 m): Item #61011
- 100 ft (30.5 m): Item #61014
Troubleshooting reduced or no airflow
If the Pro Air 20 or Pro Air 60 produces weak airflow, fewer bubbles, or no bubbles, check the following:
- Check electrical power. Confirm that the compressor is connected to a working GFCI-protected outlet and that the GFCI has not tripped.
- Inspect the check valves. Verify that each valve is installed in the correct direction to allow air to flow toward the diffuser.
- Inspect the airline tubing. Check for kinks, restrictions, or damaged sections.
- Inspect the diffusers. Look for debris, mineral buildup, or other restrictions affecting bubble output.
- Check the air inlet sponge filter. Clean or replace the filter if it is clogged.
- Inspect compressor components. If airflow remains weak after checking the tubing, diffuser, and inlet filter, the internal diaphragm may be worn and require replacement.
Important: If a kinked airline or dirty diffuser significantly restricts airflow, shut off the compressor immediately to prevent overheating.
How often should aeration diffusers be cleaned or replaced?
Air stones and aeration diffusers do not have a fixed replacement schedule. Their lifespan depends on water conditions, use, and maintenance.
Inspect the diffusers at least once per season, or more frequently when debris or mineral buildup is present.
Signs that cleaning or replacement may be necessary include:
- Reduced airflow or fewer bubbles.
- Uneven bubble distribution.
- Visible cracks or physical damage.
- Restricted airflow that does not improve after cleaning.
Cleaning an aeration diffuser
- Disconnect electrical power to the compressor.
- Remove the diffuser from the pond.
- Inspect the diffuser for accumulated debris or mineral deposits.
- Carefully clean accessible buildup without damaging the diffuser membrane.
- Reinstall the diffuser and check bubble output.
For stubborn mineral buildup, Aquascape Pump Cleaner Maintenance Solution — Item #91143 may be considered after confirming that the cleaning solution is suitable for the diffuser material. Follow the cleaner's product instructions.
If the diffuser is damaged or airflow remains restricted after cleaning, replacement may be necessary.
Replacement diffuser: 10 in. (25.4 cm) Rubber Membrane Aeration Diffuser — Item #61010
Routine compressor maintenance
Routine maintenance helps maintain airflow and extend compressor life.
- Inspect the air inlet sponge filter at least annually.
- Inspect the filter more frequently in dusty environments or if the compressor produces unusual noises.
- Rinse a dirty sponge filter with clean water and allow it to dry thoroughly before reinstalling.
- Keep the compressor's air inlet free of accumulated debris.
- Replace worn diaphragms and other serviceable components as necessary.
Replacement compressor maintenance parts
Pro Air 20:
- Pro Air 20 Compressor Renew Kit — Item #61015.
Pro Air 60:
- Pro Air 60 Air Inlet Sponge Filters — Item #61005.
- Pro Air 60 Replacement Diaphragm — Item #61007.
Compressor diaphragms are wear components and may require periodic replacement. Diaphragm wear is not covered under the product warranty.
Winter operation
The Pro Air 20 and Pro Air 60 can operate during freezing weather to help maintain an opening in the pond's ice for gas exchange.
For winter operation:
- Position the diffuser approximately 12–18 in. (30–46 cm) below the water surface.
- Do not place the diffuser at the bottom of the pond during winter. Deep aeration can disturb the warmer water where fish overwinter.
- Monitor airflow and pond conditions throughout the winter.
- If the compressor will not operate during winter, cover it or store it in a frost-free location.
Pro Air 20 and Pro Air 60 product information
Pro Air 20 Pond Aeration Kit — Item #61009
- Recommended pond volume: Up to 5,000 US gal (18,927 L).
- Maximum recommended pond depth: 6.5 ft (1.98 m).
- Compressor power consumption: 15 W.
- Maximum loaded airflow: 0.71 CFM (20 L/min).
- Included diffuser: One 10 in. (25.4 cm) rubber membrane diffuser.
- Included airline tubing: One 30 ft (9.14 m) roll.
View Pro Air 20 Pond Aeration Kit
Pro Air 60 Pond Aeration Kit — Item #61008
- Recommended pond volume: Up to 15,000 US gal (56,781 L).
- Maximum recommended pond depth: 11.5 ft (3.51 m).
- Compressor power consumption: 45 W.
- Maximum loaded airflow: 2.1 CFM (60 L/min).
- Included diffusers: Two 10 in. (25.4 cm) rubber membrane diffusers.
- Included airline tubing: Two 30 ft (9.14 m) rolls.
- Included manifold: Two-way airflow manifold.
View Pro Air 60 Pond Aeration Kit
If troubleshooting does not restore normal airflow, submit a request through the Aquascape Customer Care contact form.