If your AquaSurge Adjustable Flow Pond Pump is not responding to the Universal Remote, the receiver may be in bypass mode, the remote battery may be weak, or the remote may need to be paired with the receiver.
Check the receiver and remote
- Check the receiver switch. Make sure the switch on the Smart Pump Receiver is set to Position 1 (O/OFF). Position 2 (ON) bypasses remote control and operates the pump at full flow.
- Check the remote battery. Make sure the battery is functioning. If necessary, replace it with a new 23A, 12 V battery.
- Check the distance. The Universal Remote has an approximate operating range of 150 ft (45.7 m). Obstacles between the remote and receiver may reduce the range.
- Check the power supply. Make sure the Smart Pump Receiver is connected to a working, outdoor-rated GFCI outlet.
Re-pair the remote to the receiver
If the remote still does not respond, follow these steps to re-pair it with the Smart Pump Receiver.
- Make sure the receiver's switch is set to Position 1 (O/OFF).
- Disconnect the Smart Pump Receiver from its power source, then reconnect it.
- On the remote, press and hold the + and – buttons simultaneously for more than 3 seconds, until the numbers on the remote's display begin flashing.
- Use the + or – buttons to select 2 for the Smart Pump Receiver used with AquaSurge Adjustable Flow Pond Pumps.
- Press the power button on the remote to complete pairing.
Important: The pairing process must be completed within 1 minute of reconnecting power to the receiver.
Once paired, use the remote's + and – buttons to adjust the pump's flow between settings 1 and 10.
If the remote still does not respond
Try replacing the remote battery and repeating the pairing procedure.
If the issue continues, please submit a request through our Aquascape Customer Care contact form.
For additional instructions, see the Universal Remote for Adjustable Flow Pumps manual.