Follow these steps to replace the tubing on your Aquascape Dosing System SL using the replacement Tubing Kit (Item #96089).
- Disconnect power. Unplug the Dosing System SL from its power source.
- Open the enclosure. Lift the lid to access the control panel and tubing connections.
- Remove the old tubing. Disconnect the tubing being replaced from its connections.
- Install the new tubing. Connect the tubing to the appropriate fittings. Use the inlet and outlet indicators on the pump cartridge to identify the correct connections. Secure the tubing using the provided clips.
- Reconnect power. Plug the system back into its power source.
- Prime the system. Hold the setting button for 3 seconds until the blue light flashes. Allow the treatment to move through the tubing. Priming will stop automatically, or you can press the setting button once treatment begins dispensing.
Important: Position the discharge tubing above the water level of your water feature.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.