Aquascape spitters connect to a submersible fountain or statuary pump using flexible tubing. Use the recommended pump or flow rate for your specific spitter.
Installation
- Place the spitter in the desired location.
- Connect flexible tubing to the inlet on the spitter.
- Connect the other end of the tubing to the discharge fitting on the pump.
- Place the pump completely underwater in the pond, fountain, or basin.
- Make sure the tubing is not kinked, pinched, or restricted.
- Plug the pump into a properly grounded GFCI-protected outlet.
- Adjust the pump flow, if adjustable, until the desired spitter flow is achieved.
Important
- The pump must remain fully submerged while operating.
- Position the spitter so all water returns to the pond, basin, or fountain.
- If water flow is weak, check for kinked tubing, debris, or an improperly sized pump.