Weak or no water flow from an Aquascape Spitter is usually caused by a pump problem, restricted tubing, or a clogged spitter outlet.
Check the pump
- Make sure the pump is plugged in and operating.
- Make sure the pump is completely submerged.
- Inspect and clean the pump intake.
- Remove leaves, algae, or debris blocking the pump.
- Make sure the pump flow control is not turned down too far.
Check the tubing
Inspect the tubing for:
- Kinks
- Pinched or crushed areas
- Debris or blockages
- Disconnected fittings
- Leaks
Straighten, reconnect, or clean the tubing as needed.
Check the spitter outlet
Debris or mineral buildup can restrict the outlet.
- Disconnect the tubing from the spitter.
- Flush clean water through the spitter.
- Carefully remove debris or mineral buildup from the outlet.
- Reconnect the tubing and test the water flow.
Do not drill, enlarge, or modify the spitter opening.
If the water flow is still weak
Verify that:
- The pump is properly sized for the spitter.
- The tubing is not excessively long.
- The tubing is not kinked, restricted, or partially blocked.
A pump that is too small or excessive restriction in the tubing can reduce water flow at the spitter.