A Pondless Waterfall reservoir may lose water while the pump is running or overflow when the pump shuts off. Common causes include evaporation, excessive splashing, water escaping the system, an overfilled reservoir, or insufficient reservoir capacity.
Why does my Pondless Waterfall reservoir lose water?
If the reservoir water level drops too low, the pump may become exposed or run without sufficient water.
Common causes include:
- Evaporation: Hot, dry, or windy weather increases water loss. Refill the reservoir as needed.
- Excessive splashing: Water may escape outside the waterfall or stream liner. Check for water splashing over rocks or along the edges.
- Water leaks: Damaged liner, loose plumbing connections, or water escaping around the waterfall can cause water loss.
- Insufficient reservoir capacity: A reservoir that is too small may not hold enough water while the waterfall is operating.
- Ice buildup: During freezing weather, ice can redirect water outside the waterfall or stream.
How to troubleshoot low water levels
- Turn off the pump if the water level is too low to keep it submerged.
- Inspect the water level through the Pondless Waterfall Vault.
- Add water using a garden hose until the reservoir reaches the proper operating level.
- Restart the waterfall and check for splashing or water escaping outside the lined area.
- If water loss continues, inspect the liner and plumbing connections for leaks.
Important: Never allow the pump to run without sufficient water. Running dry can damage the pump.
Why does my Pondless Waterfall reservoir overflow when the pump stops?
When the pump shuts off, water remaining in the waterfall, stream, and plumbing drains back into the underground reservoir. If the reservoir cannot hold the returning water, it may overflow.
Common causes include:
- Overfilled reservoir: Adding too much water while the waterfall is running can cause overflow when the pump stops.
- Insufficient reservoir capacity: The reservoir should hold approximately twice the water volume circulating through the waterfall and stream.
- Plumbing backflow: Water in the plumbing may drain backward into the reservoir when the pump stops.
- Automatic fill valve: An improperly adjusted fill valve may maintain the water level too high, leaving insufficient room for returning water.
How to prevent reservoir overflow
- Turn off the pump and allow water from the waterfall and stream to drain back into the reservoir.
- Check the water level through the Pondless Waterfall Vault. Water should remain contained within the reservoir.
- If the reservoir is overfilled, remove excess water.
- Inspect the check valve, if installed, to ensure it is operating properly.
- Check the automatic fill valve, if installed, to ensure the water level is not set too high.
- If overflow continues, evaluate whether additional underground water storage is needed.
Important: Do not permanently lower the reservoir water level without confirming that the pump will remain adequately submerged while operating.
When to seek additional assistance
Some water loss from evaporation and splashing is normal. However, frequent refilling, repeated pump exposure, or continued reservoir overflow may indicate a problem requiring further inspection.
If you need additional assistance, please submit a request through our Customer Care contact form.