When using the Controller System Add-on Kit to add two treatments simultaneously set each controller the same way you normally would if you were using only one controller. Each controller should be programmed based on the full volume of the pond, using the recommended settings shown in the dosing charts or in the controller setting section of the website. Because the two controllers are dosing different treatments, each one should be set for the pond’s total water volume. Do not split the pond volume between the controllers.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.