When first setting up the system or adding a new water treatment bottle, the system must be primed to push the treatment through the output tubing. Follow the steps below to complete the priming process:
Priming Options
The system can be primed using either the Smart Control App or manually.
Manual Priming Process
-
Activate Priming Mode:
- Press and hold the x2 button for 3 seconds until the blue light above the button begins to flash.
- The flashing blue light indicates the system has entered priming mode.
-
Priming Process:
- The pump will push the water treatment through the tubing during this mode.
-
Automatic Shutoff:
- Priming mode will automatically deactivate after approximately three minutes, returning the system to normal operation.
-
Early Exit from Priming Mode:
- If the treatment begins to discharge at the end of the tubing before the automatic shutoff, press the x2 button once to exit priming mode.
Importance of Proper Priming
- Accurate Dispensing: Ensures the system is ready to dispense water treatment effectively.
- Environmental Balance: Maintains a healthy and balanced aquatic environment by delivering the proper treatment dosage.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.