The Aquascape Smart Control App allows you to control and monitor your Smart Pond Dosing System XT (Item #40040) from a smartphone or tablet. You can adjust treatment dosing, prime the system, and receive low-treatment alerts.
Download and connect the Smart Control App
- Download the Aquascape Smart Control App for iOS or Android from the Smart Control App page.
- Open the app and select Create New Account, or sign in to an existing account.
- Make sure the Smart Pond Dosing System XT is connected to power and within range of a 2.4 GHz Wi-Fi network.
- Confirm that the blue indicator light is flashing, indicating pairing mode.
- Select the three-line menu in the upper-right corner of the app.
- Select Add New Device and follow the on-screen instructions to complete pairing.
Adjust treatment dosing
After connecting the Smart Pond Dosing System XT, use the Smart Control App to manage treatment dosing.
The appropriate dosing setting depends on the size of your water feature and the selected treatment concentration.
For recommended settings, refer to the Smart Pond Dosing System XT setting selector.
Important: Use only Aquascape Simple Solution XT water treatments specifically formulated for the Smart Pond Dosing System XT. Other treatments may damage the system and void the warranty.
Prime the dosing system
The Smart Pond Dosing System XT must be primed during initial setup and whenever a new treatment bottle is installed.
Priming can be started through the Smart Control App or manually from the controller.
To prime manually:
- Press and hold the x2 button for 3 seconds until the blue light flashes.
- Allow the treatment to move through the tubing.
- Press the x2 button again when treatment begins flowing from the discharge tubing.
Priming automatically stops after approximately 3 minutes if not stopped manually.
Monitor treatment levels
The Smart Pond Dosing System XT sends a low-treatment notification through the Smart Control App when the treatment bottle is approximately 90% empty.
Replace the treatment bottle when notified to help maintain consistent dosing.
If the system will not connect to the app
- Confirm that the controller is receiving power.
- Verify that your Wi-Fi network operates on 2.4 GHz.
- Check that the Wi-Fi network name and password are correct.
- Confirm that the controller has adequate Wi-Fi signal strength.
- If necessary, reset the controller by holding the + and – buttons simultaneously for 5 seconds within 1 minute of connecting power. Release the buttons when the display shows 88.
- Follow the app's pairing instructions again.
For additional assistance, submit a request through the Aquascape Customer Care contact form.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.