The Smart Pond Dosing System XT can dispense two different treatments using the optional Smart Pond Dosing System Controller Add-On Kit — Item #40042. With two treatments installed, use two 64 US fl oz (1.89 L) XT treatment bottles.
The add-on kit includes a second control panel, treatment intake assembly with low-treatment alert, and tubing/cables.
Install the second controller and treatment
- Open the XT enclosure and slide the second control panel into the available tracks inside the lid.
- Remove the rubber elbow covering the secondary power cable, then connect that cable to the second control panel.
- Connect the second control panel’s outlet tubing to the unused port at the back of the enclosure.
- Connect the inlet tubing to the barb on the second intake assembly. Connect the intake assembly’s low-treatment alert cable to the second control panel.
- Place the second treatment bottle inside the enclosure. Insert its intake assembly into the bottle until sealed at the top.
- Attach the second discharge tubing to the corresponding fitting outside the enclosure. Position its discharge end above the water level where treatment will enter the water feature.
Set and prime the second controller
Use the XT Setting Selector to determine the second controller’s setting based on your water feature’s volume, bottle size, and treatment concentration. Adjust the setting using the + and − buttons.
To prime the second controller, hold its X2 button for 3 seconds until the blue light flashes. When treatment flows from the discharge tubing, press X2 again to stop. Priming stops automatically after approximately 3 minutes if you do not stop it manually.
Use only treatments designed for the Smart Pond Dosing System XT. Other treatments may damage the system and void the warranty.