To replace the intake assembly on your Aquascape Dosing System SL, use the following steps. The replacement Dosing System SL Intake Assembly is Item #96087.
- Disconnect power. Unplug the Dosing System SL from its power source.
- Remove the old intake assembly. Open the enclosure, remove the intake assembly from the treatment bottle, and disconnect the inlet tubing from the assembly.
- Install the new intake assembly. Connect the inlet tubing to the barb at the top of the new intake assembly.
- Insert the intake assembly. Place the new assembly into the treatment bottle until it seals at the top.
- Reconnect power. Plug the Dosing System SL back into its power source.
- Prime the system. Hold the setting button for 3 seconds until the blue light flashes. Allow the treatment to move through the tubing. Priming will stop automatically when complete, or you can press the setting button once treatment begins dispensing.
Make sure the tubing is securely connected and the treatment is dispensing properly.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.