To replace the treatment bottle in your Aquascape Dosing System SL, follow these steps:
- Disconnect the intake tubing and remove the old treatment bottle from the enclosure.
- Remove the intake assembly from the old bottle.
- Remove the cap and seal from the new treatment bottle.
- Insert the intake assembly into the new bottle until it is sealed at the top.
- Place the new bottle inside the enclosure and reconnect the intake tubing securely.
- Prime the system: Hold the setting button for 3 seconds until the blue light below the setting number begins flashing. Allow the treatment to travel through the tubing.
- Once treatment begins dispensing from the end of the tubing, press the setting button to exit priming mode. The system will also exit priming mode automatically when completed.
Important:
- Inspect the tubing for debris when replacing the treatment bottle and clean it if necessary.
- Only use Aquascape SL water treatments designed for the Dosing System SL. Other treatments may damage the unit and void the warranty.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.