The Dosing System SL should be primed during initial setup and whenever a new water treatment bottle is installed to ensure treatment flows through the tubing.
- Make sure the treatment bottle is securely installed and all tubing is properly connected.
- Press and hold the setting button on the control panel for 3 seconds until the blue light below the setting number begins flashing.
- Allow the system to pump treatment through the tubing. This may take a few minutes.
- Once treatment begins flowing from the end of the discharge tubing, press the setting button again to exit priming mode.
Note: The system will automatically return to normal operation when the priming cycle is complete.
If treatment does not flow
- Check that the system has power.
- Make sure the tubing is properly connected and is not kinked or blocked.
- Inspect the tubing for treatment residue and clean it if necessary.
- Repeat the priming procedure if needed.
If the system still does not dispense treatment, submit a request through our Customer Care contact form.
Not all Aquascape products are available in every country. Availability may vary due to regional requirements, local regulations, and other market-specific conditions. In some cases, products may be marketed under different names based on imperial or metric measurements, or due to country-specific product naming regulations and labeling requirements.
To determine which products are available in your region, please visit the product pages specific to your country on the Aquascape website.
For access to Safety Data Sheets (SDS) and additional product documentation, please click here.