Water leaking around the skimmer faceplate is typically caused by an incomplete silicone seal, loose or improperly installed faceplate screws, wrinkles in the pond liner, or excessive tension on the liner.
The faceplate creates a watertight connection between the pond liner and skimmer opening. If this connection is compromised, pond water may escape behind the liner.
What should I check if my skimmer faceplate is leaking?
- Silicone sealant: Missing, improperly applied, or damaged silicone can allow water to pass between the skimmer and pond liner.
- Faceplate screws: Loose, missing, damaged, or improperly installed screws may prevent the faceplate from securing the liner correctly.
- Liner position: Wrinkles, folds, or insufficient liner coverage around the opening may interfere with the seal.
- Liner tension: Rocks or boulders pulling against the liner can place excessive stress on the faceplate connection.
- Damaged liner: Tears, punctures, or an opening cut too large may prevent a watertight connection.
- Skimmer position: A skimmer that has shifted or is no longer level may place additional stress on the liner connection.
How do I correct a leaking skimmer faceplate?
If the leak is coming from the connection between the pond liner and the skimmer, the faceplate may need to be removed and reinstalled.
- Turn off the pond pump. Lower the pond water below the skimmer opening so the connection can be inspected safely.
- Inspect the faceplate and screws. Look for missing or damaged screws, visible gaps, or damage to the faceplate.
- Check the pond liner. Make sure the liner is not torn, excessively stretched, or pulling away from the skimmer opening.
- Inspect the silicone seal. If the existing seal is damaged or incomplete, the faceplate connection may need to be disassembled and resealed.
- Reinstall the faceplate using the instructions for your skimmer model. Apply a thick, continuous bead of fish-safe silicone sealant around the skimmer opening, over the threaded inserts, as directed in the installation manual.
- Secure the faceplate using a hand screwdriver. Follow the screw installation sequence specified for your skimmer model. Power tools are not recommended because they may damage the threaded inserts.
- Allow the silicone to cure. Wait at least one hour before introducing water, as specified in the skimmer installation instructions.
- Refill the pond and check for leaks. Inspect the faceplate connection to determine whether the water loss has stopped.
Important: Do not cut additional liner away from the opening when correcting a leak. Removing too much liner can prevent the faceplate from forming a proper seal.
Are there differences between skimmer models?
The Signature Series 200, 400, and 1000 Skimmers use similar sealing methods, but their faceplate installation procedures differ.
- Signature Series 200: The liner is positioned and cut before the faceplate is secured. The faceplate is installed over a bead of fish-safe silicone sealant around the skimmer opening.
- Signature Series 400: The exterior liner plate secures the pre-cut pond liner against the silicone-sealed skimmer opening.
- Signature Series 1000: The silicone is applied before the liner and exterior liner plate are pressed into position. The liner opening is cut after the faceplate is secured. This model also uses an interior weir plate assembly.
Always follow the installation procedure for your specific skimmer model when reinstalling the faceplate.
What if the skimmer continues to leak?
If water continues to escape around the faceplate after the connection has been properly inspected and resealed, the liner, faceplate, threaded inserts, or skimmer housing may be damaged.
For additional assistance, submit a request through the Aquascape Customer Care contact form.